PLCD82MP
INSTRUCTION MANUAL
USA
EUROPE
IMPORTANT:
This radio is set to USA frequency by factory, if European
frequency is required please flip the frequency step switch on
the side of the unit.
After the switchover of the frequency switch, the frequency convert
function will not be valid until the RESET button has been pressed.
(The RESET button is in the rear facet of the front panel)
AUTO-LOADING DISC CD/MP3 ESP PLAYER
AM/FM-STEREO DIGITAL PLL TUNING RADIO WITH
ANTI-THEFT FLIP DOWN DETACHABLE FRONT PANEL
AND MULTI-COLOUR LCD
INFRA-RED REMOTE CONTROL FUNCTION
SPEAKER CONNECTION
DISC PLAY:
ANTENNA PLUG
YELLOW
Cleaning discs
Before playing, clean the disc with a clean, lint-free cloth.
Wipe the disc in the direction of the arrow.
7 A
AUX LINE IN
RED R
MEMORY B+
FUSE
WHITE L
BLACK(GND)
RED (B+)
0.5 A
FUSE
RCA LINE OUT
GRAY
RED R
WHITE L
FRONT
BLUE AUTO ANT
+
+
WHITE
FRONT
RIGHT
SP
WHITE/BLACK
GREEN
GRAY/BLACK
VIOLET
NOTE:
. Do not use so solvents such as benzine, thinners. Commercially available
cleaners or anti static spray damage the unit.
LEFT
SP
+
+
REAR
REAR
GREEN/BLACK
VIOLET/BLACK
Do not insert a disc with the label surface down. Doing so may damage the
unit.
NOTE:
1. In spite of having any kinds of speaker system, must use 4 ohms
impedance of speaker to reduce the distortion during high volume level.
2. Do not allow the auto antenna wire and ground touch each other.
Label
surface up
SPECIFICATION
GENERAL
NOTE:
Power requirement...............................................................................................DC 13.8V.
Current consumption..............................................................................................7A MAX.
POWER OUTPUT...................................................................................................4 X 40W.
FM SECTION
Frequency range.......................................................................87.5MHz -108MHz(EUROPE)
Frequency range..........................................................................87.5MHz -107.9MHz(USA)
Usable sensitivity..........................................................................................................3uV.
I.F Frequency.......................................................................................................10.7MHz.
AM SECTION
. Do not try to insert another disc when one has been already inserted.
Doing so may damage the unit.
.Handle the disc by its edge. And to keep the disc clean, do not touch
the surface.
Frequency range......................................................................522KHz - 1620KHz(EUROPE)
Frequency range............................................................................530KHz - 1710KHz(USA)
I.F Frequency..........................................................................................................450KHz
Usable Sensitivity........................................................................................................40dB
LINE - OUT [OPTION]
Output......................................................................................................CD MAX 800mv
CD PLAYER
.Do not stick paper or tape on the disc.
System........................................................................................compact disc audio system.
Usable disc................................................................................CD/CD-R/CD-RW/MP3 disc
No of quantization bits 1bit.
Signal format.............................................................................sampling frequency 44.1KHz.
Frequency characteristics............................................................................20-100Hz < 5dB
10-20KHz < 5dB.
.Do not expose the disc to direct sunlight or heat sources such as hot air
ducts. Or leave it in a car parked in direct sunlight where there can be a
considerable rise in temperature.
Signal to noise CD............................................................................................50dB [1KHz]
Number of channels..............................................................................................2 STEREO.
Chassis dimensions.......................................................................178[W] X 50[H] X 165[D].
9
2
REMOTE CONTROL BASICS BATTERY REPLACEMENT:
1.Remove the battery holder as the direction indicated by the arrow.
2.Replace the battery Set a new battery property with (+)side up.
3.Insert the battery holder. Push in the holder to the original position.
INSTALLATION
INSTALLATION WAY
IT IS AN ANTI-THEFTINSTALLATION WAY. THECHASSIS WEAR A METAL
NOTE ON BATTERIES:
Old batteries must immediately be removed and disposed.
SLIDING HOUSING. PLEASE HAVE THE WIRING CONNECTIONOF THE
POWER SUPPLY, SPEAKERS AND ANTENNAAS FOR THE REQUIREMENT
OF THE MANUAL, THENINSTALL THE METAL SLIDING HOUSING INTOTHE
CAR ACCORDING TO THEDIAGRAM.
TO BOOST UP THECAPABILITY OF
ANTI-JAMMING, PLEASE FIX THE
METAL STRAP ONTHE METAL
CONNECTED TO THE BOTTOM
BRACKET OF THE CAR.
BATTERY INFORMATION:
Designated Battery: UM-4"AAA"/R05
Battery Life: 6 months with normal use (in normal room temperatur)
SELECT THE PROPER FIXER
FOR FIXING THE SLIDING
METAL HOUSING.
METAL STRAP
CAUTION:
Improper use of batteries may cause overheating, explosion or ignition. Resulting in
jury or fire .Battery leakage may cause damage to the unit.
Do not disassemble or short the batteries. Do not throw the batteries into the fire.
To avoid the risk of accident, keep the batteries out of reach of children.
UNIT CHASSIS
PLASTIC TRIM OUT
DASH BOARD
FRONT PANEL
SLIDING METAL HOUSING
TO DRAW THE CHASSISOUT OF THE
SLIDING METAL HOUSING,INSERT
THE LEFT AND RIGHTKEY PLATES
INTO THE RIGHT POSITIONOF THE
2 SIDES OF CHASSIS.
TO INSTALL THEFRONT PANEL
BACK INTO THE UNITCHASSIS,
FIRSTLY INSTALLTHE RIGHT
SIDE IF IT BACKINTO THE RIGHT
POSITION, THEN PUSH THELEFT
SIDE BACK TO THEUNIT CHASSIS
TILL OK.
NOTE
REMOVE AWAY 2SCREWS FOR PROTECT
THE DECK BEFORE OPERATING IT.
REMOVE THE SLIDING
METAL HOUSING AWAY
1. LOCAL/DISTANCE BUTTON
If you findthe receiving signal is weak andthere is the
word LOC displayed on LCD whenyou tune fordistance
station, firstly press the button todisappear the word
LOC on LCD, then tune againfor the distancestation.
If you findthe interference to the receiving signal is very
strong and there is not theword LOC displayed on LCD
when you tunefor local station, firstly press the button to
display the word LOC on LCD, then tune again for the local
station.
PRESS RESET BUTTON TORESUME
THE DISTORTED PROGRAM WHEN
THE LCD DISPLAYIMPROPERLY AND
SOME BUTTONS ARE INVALID.
RESET BUTTON
AFTER FLIPPING DOWN THE
FRONT PANEL, DRAWTHE
FRONT PANEL OUTOF THE
CLIP.
2. LOUDNESS BUTTON
Press it to enhance the BASSsound effect immediately
when it isin BASE mode.
OPEN BUTTON
TO INSERT DISC INTOCOMPARTMENT OR EJECT DISCOUT
OF THE COMPARTMENT ORTAKE THE FRONTPANEL AWAY
THE UNIT CHASSIS, PRESSTHE OPEN BUTTON TOFLIP
DOWN THE FRONT PANEL.
3
8
LOCATION AND FUNCTION OF CONTROLS
12. PRESET STATION [ 1-6 ] AND TOP/CDP, INT, RPT, RDM BUTTONS.
(A].To memorize the current frequency, press any one of the six
preset buttons hold for more than 2 seconds.
(B].To recall the preset memory, press one of the preset buttons
[1-6].
(C).In CDP mode, press TOP/CDP button to pause CDP playback,
press it again to resume CDP playback. Press it hold for more
than about 0.5 seconds to play the first track of the disc.
(D).In CDP mode, press INT button to play the first 10 seconds part
of each track, press it again to stop INT mode and retain playing
the track currently selected.
(E).In CDP mode, press RPT button to play the current track repeatedly.
Press it again to cancel this mode.
(F).In CDP mode, press RDM button to play the track in random order.
Press it again to cancel this mode.
(G).In MP3 mode, M5 and M6 is assigned as 10 TRACK up/down when
normal play.
1. V-SEL/MENU/ENTER(SEL) AND V-UP/DN, MENU-UP/DN(+/-) BUTTONS
(1).Press SEL button shortly and repeatedly to select sound mode VOLUME,
BASS(without preset DSP), TREBLE(without preset DSP), BALANCE and
FADER, then press + or - button to adjust level of the selected sound mode.
(2).Press SEL button hold for more than 1 second to turn on MENU mode,
and the LCD will display DSP OFF/POP M/ROCK M/CLASS M/FLAT M,
then press SEL button shortly and repeatedly to select ESP12/ESP45,
BEEP ON/BEEP OFF, SEEK1/SEEK2, VOL LAST/VOL ADJ(When it is in
VOL ADJUST mode, the next mode will be A-VOL after VOL ADJUST mode,
then you can adjust the volume level) in the sequence and circulation.
After select the desired MENU mode, press + or - button to select the
mode of the selected MENU.
(3).TRACK SEARCH MODE during MP3 mode:
A.Press A.P button once to select TRACK SEARCH mode, the LCD will
display TRK SCH.
B.Press SEL button to enter TRACK mode, the LCD will display 001 and flash
unit s digit 1. Then press + or - button to shift the unit s digit from 0 to
9 as a loop rotation. (Finally press SEL button hold for more than 0.5
seconds to play the selected track)
13. MODE BUTTON
Press it to select RADIO or CDP mode.
14. INFRA-RED REMOTE CONTROLLING SENSOR
CAUTION: Do not install the detachable panel before connecting the wire.
1. The unit is designed for negative terminal of the battery which is connected to the
vehicle metal. Please confirm it before installation.
2. If the car interior is extremely hot, as after being parked in the sun, do not use
the player until the car has been driven for a while to cool off the interior.
3. Press the OPEN button to flip down the front panel (see fig.1), then take away the
front panel (see fig.2) and put it in the protective case (see fig.3) safe keeping.
4. Install the front panel back into its bracket and then push it back to the position for
playing (see fig.4).
C.Press SEL button to flash tens digit, then press + or - button to shift the
tens digit from 0 to 9 as a loop rotation.(Finally press SEL button hold for
more than 0.5 seconds to play the selected track)
D.Press SEL button to flash hundreds digit, then press + or - button to shift
the hundreds digit from 0 to 9 as a loop rotation.
E.Press SEL button to play the selected track.(If the selected track number
is bigger than the biggest track number in the MP3 disc, it will play the
last track in the MP3 disc.)
7
4
(4). FILE SEARCH during MP3 mode:
A. Press A.P button shortly twice to select FILE SEARCH mode, the
LCD will display FILE SCH.
B. Press SEL button shortly once to select and display the first folder.
Then press + or - button to select the folder with step by step forward
or backward.
(2)In CD mode, press ^ button to play next track. Press v button
once to play the current track from the beginning of the current
track, press v button twice continuously to play the last track.
Press ^ or v button hold to skip forward or backward.
5. AUTO-STORAGE/PRESET MEMORY SCAN BUTTON
* Press SEL button hold for more than 0.5 second to play the first
track of the selected folder.
(1)In radio mode, press it to perform all stations memory for 5 seconds
each time, while memory digital and frequency will flash on LCD. If
the button is pressed for more than 2 seconds, it will seek station
on current band, then write to the preset memories. When the
auto-storage operation is completed, it will automatically perform
for 5 seconds each time. During the memory station performing,
press 1-6 digital buttons to select and stop scanning function.
(2)In MP3 mode, press A.P button repeatedly to select TRACK SEARCH,
FILE SEARCH or CHARACTER SEARCH mode.
C. Press SEL button shortly once to select and display the first track
of the selected folder. Then press + or - button to select the track
in the folder with step by step forward or backward.
D. Press SEL button shortly once to play the selected track.
(5). CHARACTER SEARCH MODE during Mp3 mode:
A. Press A.P button shortly three times to select CHARACTER SEARCH
mode, the LCD will display CHAR SCH.
B. Press SEL button shortly once to display A in the first digit from left
to right. Then press + or - button repeatedly to select one of A-Z
and 0-9 and * to replace A. At this time press SEL button hold for
more than 0.5 seconds to play the track which first character is
the selected one.
6. BAND BUTTON
Press it repeatedly to select your desired radio band during RADIO
mode.
C. Press SEL button shortly once to display A in the second digit from
left to right. Then press + or - button repeatedly to select one of A-Z
and 0-9 and * to replace A.
D. Press SEL button shortly once to display A in the third digit from
left to right. Then press + or - button repeatedly to select one of A-Z
and 0-9 and * to replace A.
7. CLOCK BUTTON
Press CLK button to display time on LCD, then press CLK button
hold until time flashes on LCD, thirdly press + or - button to adjust
HOUR or MINUTE.
8. SCAN BUTTON
E. Operate as same as above to select the character in the fourth, fifth,
... Xth digit from left to right.
F. Press SEL button hold for more than 0.5 second to play the track
that the name selected.
Press it to scan up by one channel step with station detection. If a
valid signal has detected, the current frequency is blinked within 5
seconds, then press it again to stop scan and remain the current
frequency; otherwise, the unit continue to scan up by one channel
step with station detection 5 seconds later.
NOTE: During CHARACTER SEARCH mode, press A.P button to
delete the last character.
9. POWER BUTTON
2. OPEN BUTTON
Press any button except the EJECT and OPEN button to turn on the
unit, press PWR button hold for more than 0.5 seconds to turn off
the unit.(After switching on the ACC POWER first time for 3 seconds,
can only turn on the unit)
Press it to flip down the front panel and you can insert the disc
into the CD compartment or press the EJ button to eject the disc
from the disc compartment or take away the front panel.
3. LCD (LIQUID CRYSTAL DISPLAY)
10.STEREO/MONO BUTTON
Press it repeatedly to select STEREO or MONO sound mode.
4. UP AND DN BUTTONS
(1)In RADIO mode, press ^ or v button shortly and repeatedly to
manually tune up or down for the desired radio station with step by
step. Press ^ or v button hold for more than 0.5 seconds to
auto-matically tune up or down for the radio station of strong signal.
11.MUTE BUTTON
Press the button to eliminate or resume the sound immediately.
To resume the sound immediately, can also press MODE, BAND, +,
-, (LOUD) and SEL button.
5
6
|